| 产地 | 河北定州 |
|---|---|
| 品牌 | 海韵牌 |
| 型号 | BT-6003 |
海韵牌BT-6003型快硬高强微膨胀灌浆料Chaton brand BT - 6003 type fast GaoJiangWei expansion grouting material hard检验标准：YB/T9261-98灌浆材料行业标准inspection standards: YB/T9261-98 grouting material industry standard产品介绍Product introduction 海韵牌BT-6003型快硬高强微膨胀灌浆料与传统的细石混凝土及环氧化砂浆相比，具有流动性更好、强度更高、耐老化、耐高温、高抗渗、防蜕变、无收缩、膨胀性好、施工易于控制、简便快捷等特点。其1天强度大于30MPa，设备安装后24小时可试运转，28天强度达到90 MPa，达到或超过YB/T9261-98灌浆材料行业标准。 Chaton brand BT-6003 type fast expansion grouting materials and hard GaoJiangWei traditional fine stone concrete and epoxy mortar, compared with liquidity of better, strength higher, ageing resistance, high temperature resistant, strong permeability, and prevent trans-forming, non-shrink, expansile good, construction easy control, simple and rapid etc. Characteristics. Its strength is greater t**y 30MPa, equipment installation May 24 hours after trial operation, 28 days strength achieves 90 MPa, reach or exceed YB/T9261-98 grouting material industry standard. 技术特点Technical features 旱强、高强 海韵牌BT-6003型快硬高强微膨胀灌浆料**强度可达30MPa以上，设备安装完毕**后可运行生产。 Drought strong, high-strength chaton brand BT-6003 type fast GaoJiangWei expansion grouting material hard day intensity can reach 30MPa above, equipment installation ends after one day can run production. 自流态 现场只需加水搅拌后，即可进行施工，不需振捣便可充填全部间隙。 Their only after water mixing modal on-site construction, and then, do not need to vibration can be filling all clearance.微膨胀 以保证灌浆料与基础紧密接触。 Micro expansion to ensure grouting materials and basic close contact.耐久性 200万次疲劳实验，50次冻融循环试验，强度无明显变化。 Durability 200 million times fatigue experiments, 50 times freeze-thaw cycles test, intensity is no change.抗油渗 在机油中浸泡30天后其强度比浸油前提高10%以上。 Of oil and permeability in oil soak 30 days before its strength than immersed increase by 10%. 施工技术与方法The construction technology and method BT-6003灌浆料的施工不仅应符合本施工技术方法的规定，尚应符合现行《混凝土结构工程施工及验收规范》（GB50204）、《混凝土结构设计规范》（GBJ10）、《混凝土结构加固技术规范》（CECS25）及《水泥基灌浆材料施工技术规程》（YB/T9261-98）中的有关规定。 BT-6003 grouting material construction should not only conforms to the construction technology and methods, there should be in line with the provisions of the existing concrete structure engineering construction and acceptance of rules "(GB50204), the design specification for concrete structures" (GBJ10), the concrete inforcement technical specification (CECS25) and the cement base grouting material construction technical regulation (YB/T9261-98) the relevant provisions. 附录B 锚固地脚螺栓施工工艺The appendix B anchor bolts construction craft清除螺栓表面油污及铁锈↓清理孔→清除孔内积水→调整及固定插入螺栓→浇注→养护→安装设备↑配制灌浆料 灌浆方式分为：自重法灌浆、高位漏斗法灌浆、压力法灌浆、轨道基础灌浆 Grouting way is divided into: weight method grouting and high pressure grouting and funnel method, rail base grouting method grouting